How do you calibrate an e nail
Turn on your BOSS E-Nail and use the Up/Down Arrow Keys to set the temperature to 400 degrees. Once your E-Nail reaches 400 degrees, hold down the ">" button for a few seconds until it's starts blinking quickly – Then release the button. This puts it in "Auto-Tune" mode.
How do I setup my email
Go to Settings > Add account > Other. Enter your full email address, such as yourname@hotmail.com and then tap Manual Setup. Choose Personal (IMAP) or Personal (POP3). Enter your password and tap Next.
How do you set up an Enail dab
Load Your Dab & Hit Your Enail Rig!
Place the dab on the surface of your enail after it comes to temp, and slowly rotate the tool to vaporize everything. Next, cover your nail with a carb cap. Once you're ready, inhale your hit through the mouthpiece and enjoy!
How many watts does an eNail use
The Classic eNail uses a 120-watt, 20 mm coil that comes with a six-month warranty and comes with an all-in-one titanium nail that will fit on any rig, regardless of whether it is male or female or 10 mm, 14 mm or 19 mm.
How many amps does an eNail use
It is very efficient as it runs on only 1 amp (~89 watts); so there is much less power usage than the other Enail companies that run on 5 amps (~240 watts).
How do you hit an Enail
Use an eNail for complete temperature control
Using an electronic nail takes all the guesswork out of dabbing. Simply plug the eNail into the wall, set the desired temperature, and wait a few seconds for it to reach the predetermined temperature.
What is the Set button for on my Enail
However, 99.99% of e-nail users will want to just avoid this button. The up/down arrows are all you need to adjust the set temperature setting. It's as simple as that! The screen will blink a few times on your screen before or during the change.
What does eeee mean on my Enail
"EEEE" means that the controller box is not getting a proper reading from the heater coil. This will happen when you unplug the heater coil from the box while it is turned on.
How do I reprogram my Enail
Once your E-Nail reaches or past the set temp the simply hold down the right “>” button for 10 seconds until it's starts blinking quickly – Then release the button. This puts your 710 life enail into “Auto–Tune” mode. During “Auto–Tune” Mode, the red light will blink rapidly and consistently for about 5 minutes.
Where do I find my email account settings
Go to the home screen and select Email. Tap the Menu button and select the Settings icon. Tap Account Name and then tap Server settings. Make your edits, then click Done.